Sencore MRD 5800 - Page 73

MRD 5800 – User Manual
Page 73 (116)
Setting
Range
Description
Transmit
Enabled
Disabled
Enable or disable transmission of de-encapsulated
MPE data.
Physical
Connector
Port 1
Port 2
The physical connector on the MPEG/IP card that
will be used to transmit the MPE data.
PID
Selected MPE PID from the transport stream to use
for MPE output
MAC Filter State
Enabled
Disabled
Enable or Disable the filtering of output data based
on a MAC address in the selected MPE PID
MAC Address
00:00:00:00:00:00
FF:FF:FF:FF:FF:FF
Filtered MAC address that will be transmitted in the
MPE output. All data with other MAC addresses in
the selected MPE PID will be discarded