Sencore OmniHub 6 User Manual

OmniHub 6/6D– User Manual
Page 100 of 182
To Output the TS by Bypass mode, you can simply check the Bypass box of the TS.
You can only bypass 1 TS and cannot output other services from different channel
sources. Bypass mode allows you to keep the input signal automatically be redirected
to Modulation output without re-scanning the input or transferring it to output.
Multiplexing-Service Configuration> After output the services from IP input to
Modulation output, you can now edit the Service ID and other PID on the output. Click
on the Service Configuration to see this page, it shows the output service on this
channel only.
You can click the Name of the service and it will show a table where you can modify
some information of the service like Service ID, Service Name, Service Provider, PCR
PMT AUDIO and Video PID. Click OK for the changes to take effect.
Here you can also edit the Original Network ID,TS ID and Modulation Mode of the
Modulation Output.

Sencore OmniHub 6 Specifications

General

Brand	Sencore
Model	OmniHub 6
Category	Media Converter
Language	English