OmniHub 6/6D– User Manual
Page 119 of 182
TS setting: Please refer to IP Output service configuration on baseboard IP output.
LCN setting: You need to add NIT streams of all frequencies to the base TS
(frequency), which is for your STB to automatically search and identify all the TS
(frequencies) LCN information.
Check or reset Original Network ID and TS ID of each TS (frequency). Each TS should
have different IDs.
Fill the Original Network ID and TS ID of each TS (frequency) in the field of the base
TS (frequency) and then click Add to create a NIT stream for this TS (frequency).
Click +Descriptor then LCN Descriptor to check all the programs which are
contained in this frequency. Then set programs LCN.
To Next Page
Loading...
