EasyManuals Logo

Sencore OmniHub 6 User Manual

Sencore OmniHub 6
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
OmniHub 6/6D– User Manual
Page 42 of 182
To use Multiplexing mode on service level click on the pencil icon on the right side
in the line with the proper service. Then select the output stream (channel) where the
service will be multiplexed.
Do not forget to click the Apply button on the right side to make the change takes
effect.
To clear the whole routing table, click button.
There is a channel scan button on top. Normally
the input service list of each channel will show on this page, but when you change the
input source, you should refresh the changed channels manually by selecting the
channel and clicking Channel Scan button.
3.3.5.4 Modules System
System tab allows you to perform the following tasks:
- Import / export license
- Log manages
- Reboot
- Factory Default
To open the log management menu, click on the Open button. The newly opened menu
allows you to enable / disable logging.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sencore OmniHub 6 and is the answer not in the manual?

Sencore OmniHub 6 Specifications

General IconGeneral
BrandSencore
ModelOmniHub 6
CategoryMedia Converter
LanguageEnglish

Related product manuals