OmniHub 6/6D– User Manual
Page 41 of 182
1. Bypass mode. In this mode, routes can only be done when outputting a whole
input transport stream towards an output TS channel, this cannot be done when
outputting a single service only. Bypass mode activation will not allow other
services from other input TS to be mixed in the current TS output. Any attempts
of routing other streams/services towards this channel will result in “this channel
won’t be available at this time”.
2. Multiplex mode is used to create a new SPTS or MPTS. This mode allows the
administrator to perform the following operations:
a. Route a single service towards an output channel to create SPTS.
b. Route services towards a single output channel to create MPTS.
c. Route service/s AND stream/s from multiple channels towards a single
output channel to create MPTS.
Service Configuration page interface
To use Bypass or multiplex mode on stream level, click the icon . When a new
window appears, select the output stream/channel where the stream will be bypassed or
multiplexed.
To Next Page
Loading...
Need help?
General
