OmniHub 6/6D– User Manual
Page 65 of 182
Enable Destination MAC: Generally, you do not need to enable this option. This
is reserved for exceptional cases when the unicast stream cannot be received
with using unicast IP addresses. You can enable destination MAC and streaming
out by setting Destination MAC.
To use Multiplexing mode on service level:
1. Click on (pencil) icon. There will always be a BaseBoard selection for the IP
output and other Output options depending on the module inserted.
2. Select the correct Output and Channel you want to output the service to.
3. Check Multiplex on the channel you want to outputt. You can output multiple
services to one channel or output one service to multiple channels.
OHE6-HDMI-05/05A module is a 4/8 - channel HDMI encoding module that supports
H.264. This supports AC3 and AAC via license and supports OSD Subtitle, logo picture
and QR code overlay. OHE6-HDMI-05 occupies 1 slot in the chassis and OHE6-HDMI-
05A occupies 2 slots in OmniHub 6/6D chassis.
3.4.4.1 Module Status
Like other Hdmi encoder module. The Status of OHE6-HDMI-05/05A shows the Bitrate,
input and output Resolution, TS analysis and Service List on each channel as shown in
the image below.
To Next Page
Loading...
Need help?
General
