Performing a walk test (reception quality)
167
Good reception quality is indicated by a tick.
If the tick is missing, reception quality is sufficient.
If reception quality is or was compromised at any posi-
tion, this is indicated by a warning triangle.
The warning triangle remains displayed on the display panel
even if reception quality improves afterwards.
NO LINK: If the radio link breaks down completely, the back-
ground of the display panel changes back and forth between
light and dark and No Link appears on the display panel.
▷ Press the ESC button on the receiver to end the walk test.
If the result of the walk test is not satisfying, you can take the
following remedial measures:
• If possible, reposition the receivers so that there is always a
direct line of sight between the receiver antennas and the
paired transmitter.
• If possible, remove obstacles between the transmitter and
the receiving antennae.
• When rack mounting receivers, you should mount their rod
antennae to the front of the rack using the GA 4 rack-mount
kit.
• If you have manually adjusted the transmission power, you
may have to readjust it via the receiver's operating menu:
System Settings -> RF Power. You can find more informa-
tion under „Multi-room mode“.
To Next Page
Loading...
