Multi-room mode
52
Single-room setup with SL Rack Receiver DW only
▷ Install all receivers in one rack (see „Installing receivers in
a rack“).
▷ Connect all cables for the receivers (see „Connecting the
receiver“).
▷ Mount all antennas as recommended and feasible (see
„Recommendations on antenna mounting“).
▷ Ensure that all receivers are switched off.
▷ Switch on the first receiver. This receiver will become the
Master.
▷ If necessary, pair a transmitter. Only if necessary, as the
sets are delivered already paired.
▷ Wait until both the LED of the receiver and the LED of the
transmitter light up green.
▷ Perform a walk test to ensure the best reception coverage
(see „Performing a walk test (reception quality)“).
▷ Switch on all other receivers. They will synchronize with
the Master. Make sure to leave the Master receiver
switched on during this step.
Single-room setup with SL Multi-Channel Receiver
DW only
▷ Install the SL Multi-Channel Receiver DW on a wall or the
ceiling with the front side of the receiver facing into the
room (see „Mounting the receiver“).
▷ Connect a LAN cable supplying PoE to the Dante I / PoE /
Ctrl RJ-45 socket of the first SL Multi-Channel Receiver
DW (see „Connecting the receiver“).
This receiver will become the Master.
▷ Wait until the LEDs of the receiver light up red.
▷ Connect a LAN cable supplying PoE to the respective Dan-
To Next Page
Loading...
