126 127
Sequential Prophet X User’s Guide
Global Settings
Global Settings
• With breath cc2 selected, an expression pedal connected to the filter
jack will control whatever parameter is routed to the modulation source
“Breath” within the modulation matrix.
• With foot cc4 selected, an expression pedal connected to the filter
jack will control whatever parameter is routed to the modulation source
“Foot” within the modulation matrix.
• With exp cc11 selected, an expression pedal connected to the filter
jack will control whatever parameter is routed to the modulation source
“Expression” within the modulation matrix.
• With lpf full selected, an expression pedal connected to the filter jack
will control lter cutoff frequency within its full range of 0-164 (fully
closed to fully open).
• With lpf half selected, an expression pedal connected to the filter jack
will control lter cutoff frequency within half of its range (fully closed
to half open).
22. Seq Pedal Mode: Normal, Trigger, Gate, T-G—Selects the mode
for the rear-panel sequencer jack. This jack requires a unipolar signal.
Connecting a bipolar signal can damage this input.
• With normal selected, a footswitch will start sequencer playback.
• With trig selected, an audio signal connected to the sequencer jack
will step the sequencer when the sequencer’s play button is on.
• With gate selected, an audio signal connected to the sequencer
jack will trigger and gate the envelopes while you hold a note or
chord. Additionally, turning on the sequencer or arpeggiator will add
sequencer or arpeggiator playback — but controlled by the Prophet X’s
clock bpm and value settings and not the audio trigger.
• With t-g (trigger+gate) selected, an audio signal connected to the
sequencer jack will trigger and gate the envelopes while you hold a
note or chord. Additionally, pressing the sequencer’s play button will
also add synchronized sequencer playback.
23. Sustain Polarity: Normal, Reversed—There are two types of
momentary footswitches, normally open and normally closed. Either
type can be used with the Sustain switch input. This setting allows you
to accommodate both models in case yours behaves in a way that is
the opposite of what you expect due to its polarity. (Sustain is on until
the footswitch is pressed and then it turns off, which is the opposite of
the expected behavior.) Connect your pedal and choose the appropriate
setting based on its behavior.
24. Sustain Arp: Arp hold, Sustain—Sets the function for the sustain
pedal input the rear of the synthesizer. Selecting arp hold and pressing
the sustain pedal causes the arpeggiator to hold the current arpeggio as
if you had pressed the hold button on the front panel. Selecting sustain
chooses normal sustain pedal operation.
25. Calibrate Wheels—Calibrates the Pitch and Mod wheels.
26. Calibrate Sliders—Calibrates touch slider 1 and touch slider 2.
27. Basic Program—Loads a basic template program.
28. Calibrate Filters—Calibrates the lters. You shouldn’t need to do
this under normal circumstances since the lters are calibrated at the
factory and generally don’t require re-calibration or re-tuning.
29. Update Application—Updates the Prophet X operating system. To
do this you must download the new OS to a properly formatted USB
ash drive/thumb drive (see “Formatting a USB Flash Drive” on page
120) then connect the drive to the sample import port on the rear of the
Prophet X.
30. Update Library: Factory, User 1-8, Add-On 1-32—Imports add-on
sample libraries from a properly formatted USB ash drive/thumb drive
(see “Formatting a USB Flash Drive” on page 120) connected to the
sample import port on the rear of the Prophet X.
To Next Page
Loading...
