SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - Page 36

5
Mechanical installation
Assembly
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
36
The following figure shows the required dimensions:
M5
M5
115 (4.53)
M8
10 (0.39)
20 (0.79)
86.5 (3.41)
114.5 (4.508)
Ø15 (0.59)
Ø 6.6 (0.26)
40.5
(1.59)
M6
66 (2.6)
95 (3.7) 20 (0.79)
10 (0.39)
135 (5.31)
14.6 (0.575)
20 (0.79)
X
2
X
77.5 (3.05) 67.5 (2.66) A
Y
9686885899
X, Y Housing dimensions, see chapter “Technical data”
X
2
Bore dimension
A Distance
Procedure
1. Refer to the dimension drawing in chapter “Technical data” (→ 2 98) for the hous-
ing dimensions X and Y.
2. Refer to the following table for dimensions of the tapped holes in the holding fix-
ture:
Bore dimen-
sion
Value
X
2
Housing dimension X − 30 mm (1.2 in)
3. Mark the tapped holes of the holding fixture.
4. Cut the threads for the bolts [7] at the marked points.
5. Refer to the following table for distance dimensions for the holding fixture:
Distance Value
A Housing dimension Y − 145 mm (5.71 in)
6. Mark the spacing at the installation location.
7. Mount the holding fixture at the installation location at the calculated distance.
20278543/EN – 09/2014