SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - Page 38

5
Mechanical installation
Assembly
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
38
The following figure shows the design of the through bore and the minimum clearance
in mm (in):
9 (0.4)
6.5 (0.26)
9 (0.4)
25 (0.98)
M8
40 (1.6)
M8
Z
20 (0.79) 5 (0.2)
[1]
[2]
36028797483065611
[1] Unit
[2] Cooling fins
Z Height of the through bore + T-slot (see the dimension drawing in chapter
“Technical data” (→ 2 98))
Fastening the unit from the front
INFORMATION
It is not possible to mount the unit in this way when using the handles.
Required material
• Observe the required minimum distances and clearances by using one of the fol-
lowing mounting elements:
– Suitable spacers
– Mounting plate (with an appropriate cut-out for long cooling fins)
• Suitable mounting and locking elements, e.g. M6 screws of an appropriate length
with washers
• Suitable locking devices, e.g. lock washers
20278543/EN – 09/2014