TRANSMITTABLE ORIGINAL SIZES
The following original sizes can be transmitted.
*A long original can be transmitted.
*Long originals
Depending on the resolution setting and the width of the original, there may not be sufficient space in memory to
hold a long original. When a long original cannot be entirely scanned, use direct transmission or manual
transmission (on-hook dialing).
WHEN THE LINE IS BUSY
If the line is busy when you send a fax, transmission will be re-attempted automatically after a preset interval. This
function only operates in memory transmission mode. In direct transmission mode or manual transmission mode, the
transmission will be canceled. Wait briefly and then try sending the fax again.
WHEN A COMMUNICATION ERROR OCCURS
If a communication error occurs or the other fax machine does not answer the call within a preset period of time,
transmission will be re-attempted automatically after a preset interval. This function only operates in memory
transmission mode.
Minimum original size Maximum original size
Using the automatic document
feeder
5-1/2" (height) x 5-1/2" (width)
(140 mm (height) x 140 mm (width))
8-1/2" (height) x 19-5/5"* (width)
(216 mm (height) x 500 mm* (width))
Using the document glass
–
8-1/2" (height) x 11" (width)
(216 mm (height) x 297 mm (width))
To cancel transmission...
Cancel the transmission from the job status screen.
☞ CANCELING A FAX IN PROGRESS OR A RESERVED FAX (page 4-123)
System Settings (Administrator): Recall in Case of Line Busy
This is used to set the number of recall attempts and the interval between attempts when the connection cannot be
established because the line is busy. The factory default setting is 2 attempts at an interval of 3 minutes.
To cancel transmission...
Cancel the transmission from the job status screen.
☞ CANCELING A FAX IN PROGRESS OR A RESERVED FAX (page 4-123)
System Settings (Administrator): Recall in Case of Communication Error
This is used to set the number of recall attempts and the interval between attempts when a transmission fails due to an error.
The factory default setting is attempt at an interval of 3 minutes.
To Next Page
Loading...
Need help?
General
