Sharp MX-C301W User Manual

7-74
SYSTEM SETTINGS
Contents
Network Settings
Network settings are described below. Touch the [Network Settings] key to configure the settings.
General Setting
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use
this setting to configure the IP address of the machine.
The settings are shown below.
IP Address
Enter the IP address of the machine.
IP Subnet Mask
Entry the IP Subnet Mask.
IP Gateway
Enter the IP Gateway address.
DHCP
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host Configuration
Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network, use
this setting to configure the IP address of the machine.
The settings are shown below.
Enable IPv6 Protocol
Enable this setting.
DHCPv6
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host Configuration
Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
Manual Address
Enter the IP address of the machine.
Prefix Length
Enter the prefix length (0 to 128).
Default Gateway
Enter the IP Gateway address.
Enable TCP/IP
To use the machine on a TCP/IP network, this setting
must be enabled.
Enable NetWare
To use the machine on a NetWare network, this setting
must be enabled.
Enable EtherTalk
To use the machine on an EtherTalk network, this
setting must be enabled.
Enable NetBIOS
To use the machine on a NetBIOS network, this setting
must be enabled.
Reset the NIC
This returns all "Network Settings" to the factory default
settings.
Ping Command
Use this function to check if the machine can
communicate with a computer on the network.
Specify the IP address of the desired computer and
touch the [Execute] key. A message will appear
indicating whether or not the computer responded.
* Depending on your machine specifications, only the items under "General Setting" will be displayed.
• When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see
"TURNING THE POWER ON AND OFF" (page 1-14) in "1. BEFORE USING THE MACHINE ".
• If the machine will be used on a TCP/IP network, be
sure to enable "Enable TCP/IP
" below.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, printing will not be possible.
• If the machine will be used on a TCP/IP network, be
sure to enable "
Enable TCP/IP" below.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, printing will not be possible.
• In an IPv6 environment, the machine can use LPD
or IPP protocol.

Sharp MX-C301W Specifications

General

Print Technology	Laser
Print Speed	30 ppm
Max Print Resolution	600 x 600 dpi
Max Scan Resolution	600 x 600 dpi
Copy Speed	30 cpm
Max Copy Resolution	600 x 600 dpi
Fax Capability	Yes
Max Paper Capacity	800 sheets
ADF Capacity	50 sheets
Duplex Printing	Yes
Scanner Type	Color CIS
Standard Paper Capacity	250 sheets
Connectivity	USB, Ethernet, Wi-Fi
Mobile Printing	Yes
Display	7.0-inch color touch-screen LCD
Max Paper Size	8.5 x 14 inches