Sharp MX-C301W User Manual

4-78
FACSIMILE
Contents
4
Press the [BLACK & WHITE START] key to scan the first set.
To cancel scanning...
Press the [STOP] key ( ).
5
Insert the next set of originals and press the [BLACK & WHITE START] key.
Repeat this step until all originals have been scanned.
To cancel scanning...
Press the [STOP] key ( ). All scanned data will be cleared.
6
Touch the [Read-End] key.
• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
• The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original
page scanned.
• If the memory becomes full during scanning, a message will appear and the transmission will be canceled.
• This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel Job Build....
Touch the [Job Build] key in the screen of step 3 so that it is not highlighted.
Place next original.
Press [Start].
When finished, press [Read-End].
(Pg.No.x)
Configure Read-End

Sharp MX-C301W Specifications

General

Print Technology	Laser
Print Speed	30 ppm
Max Print Resolution	600 x 600 dpi
Max Scan Resolution	600 x 600 dpi
Copy Speed	30 cpm
Max Copy Resolution	600 x 600 dpi
Fax Capability	Yes
Max Paper Capacity	800 sheets
ADF Capacity	50 sheets
Duplex Printing	Yes
Scanner Type	Color CIS
Standard Paper Capacity	250 sheets
Connectivity	USB, Ethernet, Wi-Fi
Mobile Printing	Yes
Display	7.0-inch color touch-screen LCD
Max Paper Size	8.5 x 14 inches