Sharp MX-M700N - DSPF Paper Transport Roller 2 Brake Clutch; Transport Roller

MX-M700N DSPF SECTION C – 13
g. DSPF paper transport roller 2 brake clutch
h. DSPF paper transport roller 2 clutch
1) Remove the rear cover. (See “A-(1)-a. Cabinet”)
2) Disconnect the connector, and remove the plastic E-ring, the
DSPF paper transport roller 2 brake clutch (A), and the DSPF
paper transport roller 2 clutch (B).
i. Transport roller 2 (Drive)
j. Transport roller 1 (Drive)
1) Remove the cabinet. (See “A-(1)-a. Cabinet”)
2) Remove the paper feed tray unit. (See “C-(1) Paper feed unit”)
3) Remove the No. 1 resist roller idle and the paper feed paper
guide lower unit. (See “C-(2)-e. No. 1 resist roller (Drive)”)
4) Remove the resin E-ring on cover, and remove link lever.
5) Remove the resin E-ring, and remove the bearing.
6) Remove the belt. Remove No. 1 resist roller (Drive).
7) Remove the resin E-ring, and remove the bearing.
8) Remove the electromagnetic clutch.
(See “C-(2)-g. DSPF paper transport roller 2 brake clutch” and
“C-(2)-h. DSPF paper transport roller 2 clutch”)
9) Remove the resin E-ring on shaft side.
10) Remove the lever and shaft.
A
B