Sharp MX-M700N User Manual

MX-M700N SIMULATION 7 – 2
(3) (Data saved by the MFP control PWB)
(4) (Detailed list)
Refer to the "3. List of simulation codes".
2. General
The simulation has the following functions to grasp the machine
operating status, identify the trouble position and causes in an ear-
lier stage, and make various setups and adjustments speedily for
improving the serviceability of the machine.
1) Various adjustments
2) Setting of the specifications and functions
3) Canceling troubles
4) Operation check
5) Counters check, setting, clear
6) Machine operating conditions (operation hysteresis), data
check, clear
7) Various (adjustments, setting, operation, counters, etc.) data
transfer
The operating procedures and displays depend on the form of the
operation panel of the machine.
A. Basic operation
(1) Starting the simulation
* Entering the simulation mode
1) Copy mode key ON → Program key ON → Asterisk (*) key ON
→ CLEAR key ON → Asterisk (*) key ON → Ready for input of
a main code of simulation
2) Entering a main code with the 10-key -> [START] key. ON
3) Entering a sub code with the 10-key -> [START] key. ON
4) Select an item with the scroll key and the item key.
5) The machine enters the mode corresponding to the selected
item.
Press [START] key. or EXECUTE key to start the simulation
operation.
To cancel the current simulation mode or to change the main
code and the sub code, press the user setup key.
* Canceling the simulation mode to return to the normal mode
1) Press CA key.
(Note for the simulation mode)
• Do not turn OFF the power switch on the operation panel when
the machine is in the simulation mode.
When executing the operation of mentioning above, a malfunc-
tion may be resulted. In this case, turn OFF/ON the main power
source.
• Before entering the simulation mode, check to insure that neither
print data nor FAX data are receiving.
Counters Adjustment value Others
Copy counter FAX SOFT SW., etc. Trouble history
Printer counter JAM history
FAX receive counter Destination setting
FAX send counter Language setting
All valid paper
counter
Toner save mode
setting
Trouble counter 13" setting
JAM counter Auditor setting
Counter mode
setting
Trouble memory
mode setting
Center binding
mode AMS setting
PC/MODEM
communication
trouble detection
YES/NO setting
Tag number set
value
Printers set values
Network set value

Sharp MX-M700N Specifications

General

Functions	Print, Copy, Scan, Fax
Print Resolution	1200 x 1200 dpi
Scan Resolution	600 x 600 dpi
Monthly Duty Cycle	300, 000 pages
Maximum Paper Capacity	6, 600 sheets
Max Paper Size	A3
Connectivity	USB, Ethernet, Wi-Fi
Warm-up Time	Less than 30 seconds
Hard Disk Drive	320 GB
Type	Multifunction Printer
Print Speed	Up to 70 ppm (black)
Standard Paper Capacity	1, 100 sheets
Paper Capacity	1, 100 sheets (standard)
Original Size	A3
Scanner Type	Flatbed
Duplex Printing	Yes
Display	10.1 inch color touchscreen
Memory	2 GB
Operating System Compatibility	Windows, Mac, Linux