MX-M700N FUSING SECTION N – 6
5) Remove 3 screws, and remove the web end sensor unit.
* When installing, put the boss of actuator in the inside of a
websheet.
6) Remove 2 screws of backup plate.
7) Remove the web roller (wind-up side).
* When installing, rotate the web roller until the blue line
(approx. 30cm) is hidden after installing the web roller. (rotate
the gear)
8) Remove the spring, and remove the pressure bearing.
Remove the pressure roller.
9) Remove the web tension bearing and the backup plate.
10) Remove the web roller.
To Next Page
Loading...
