MX-M700N FUSING SECTION N – 11
4) Remove the cleaning sheet table.
* If the roller is cooled down, toner may be hardened to pre-
vent removing.
* Since cleaning is performed by applying a pressure by the
spring, be careful not to deform it.
* If copy dirt is heavy, replace the cleaning sheet table with a
new one.
w. Sub heater lamp
x. Sub heat roller bearing
y. Sub heat roller
1) Remove the fusing unit. (See “(1) Fusing unit”)
2) Remove the lower cover. (See “t. Thermostat (lower)”)
3) Remove the springs.
4) Remove the thermostat terminals.
5) Remove the thermistor.
* If the picture quality may be degraded damaged by the roller
damage, change the installing position to (B).
6) Remove the sub heat roller unit.
7) Remove the lamp fixtures.
8) Remove the sub heater lamp.
9) Remove the ring, and remove the thermostat (lower) and the
sub heat roller.
B
Marks
A
To Next Page
Loading...
