MX-M700N DRIVE SECTION P – 3
a. Waste toner pipe lock detector
1) Remove the developing unit and the process unit.
(See “(1) Developing unit” in the “DEVELOPING SECTION”,
“A-(1) Process unit” in the “PHOTOCONDUCTOR SECTION”)
2) Remove the OPC drum motor and the developing motor.
(See “(2)-a. OPC drum motor”, “(a)-b. Developing motor”)
3) Remove the drum drive unit. (See “(1) Drum drive unit”)
4) Disconnect the connector, and remove the waste toner pipe
lock detector.
b. Process humidity sensor
1) Remove the developing unit.
(See “(1) Developing unit” in the “DEVELOPING SECTION”)
2) Remove the process unit. (See “a. Process unit” in the “PHO-
TOCONDUCTOR SECTION”)
3) Remove the OPC drum motor and the developing motor.
(See “(2)-a. OPC drum motor”, “(a)-b. Developing motor”)
4) Remove the drum drive unit. (See “(1) Drum drive unit”)
5) Remove the drum earth plate. Remove the set screw and the
flywheel joint. Remove the E-ring.
6) Disconnect the connector, and remove the drum drive frame.
7) Remove the parts.
8) Disconnect the connector, and remove the sensor plate.
9) Remove the process humidity sensor.
(2) Others
a. OPC drum motor
b. Developing system
1) Remove the rear cabinet.
To Next Page
Loading...
