Sharp MX-M700N - PWB SECTION; [Q] PWB SECTION; Control PWB Section Disassembly;Assembly

MX-M700N PWB SECTION Q – 1
MX-M700N
5GTXKEG/CPWCN

[Q] PWB SECTION
1. Disassembly and assembly
A. Control PWB section
(1) PCU FLASH PWB
1) Remove the ROM cover. Release the lock and remove the
PCU Flash PWB.
(2) PCU PWB
1) Remove the rear cabinet.
2) Disconnect the connector, and remove the PCU PWB.
(3) Driver PWB
1) Remove the rear cabinet and the rear cabinet upper.
2) Disconnect the connector, and remove the harness clamp and
the SCAN harness cover.
3) Remove the connector and the harness clamp. Remove the
driver PWB unit.
No. Parts
(1) PCU FLASH PWB
(2) PCU PWB
(3) Driver PWB
(4) Mother PWB
(5) Controller cooling fan motor
(6) HDD cooling fan motor
(7) HDD
(8) Soft NIC PWB
(9) MFP FLASH ROM PWB
(10) MFP controller PWB
(7)
(10)
(9)
(8)
(1)
(4)
(6)
(3)
(5)
(2)