MX-M700N ADJUSTMENTS 6 – 22
If the above requirement is not met, do the following steps.
5) Using the numeric keypad, change the adjustment value in
steps of 0.1 mm. A larger setting shifts the printed image
toward the front side.
6) Press the P or Start key. Pressing the Start key starts print
operation as well as applying the adjustment value. Check the
off-center of the printed self-print pattern image.
Repeat steps 5 to 6 until an acceptable result is obtained.
7-B Adjust the scanned image off-center in
original table mode (scan section)
This adjustment is needed in the following situations:
* The MFP control PWB has been replaced.
* The EEPROM on the MFP control PWB has been replaced.
* The scan control PWB has been replaced.
* The EEPROM on the scan control PWB has been replaced.
* The scanner (reading) section has been disassembled.
* The scanner (reading) unit has been replaced.
* U2 trouble has occurred.
(Adjustment mode selection)
1) Go through the modes specified in Simulation 50-12.
Increasing the adjustment value by 0.1 mm/step causes posi-
tion of the printed image toward the front side.
2) Using the numeric keypad, select the adjustment item
PLATEN, which is intended to adjust the off-center in original
table mode.
3) Press the Start key.
Select 2, and press
[START] key.
Press [START] key, or press
[SYSTEM SETTINGS] key.
Item
Setting
range
Default
0TRAY
SELECT
Paper feed tray selection 1 – 5 –
1 COPY
START
Copy START (Default) – –
2 MAGNIFICA
TION
Print magnification ratio 25 –
400%
100
(Off-center adjustment value)
3 PLATEN OC mode adjustment 0 – 99 50
4 SPF SIDE1 SPF front surface
adjustment
5 SPF SIDE2 SPF back surface
adjustment
50
1
2
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. SELECT 0-9, AND PRESS
START.
0.TRAY SELECT 1 1.COPY START
2.MAGNIFICATION 100
(ADJUSTMENT DATA)
3.PLATEN 50 4.SPF SIDE1 50 5.SPF SIDE2 50
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. NOW COPYING.
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. INPUT VALUE 0-99, AND
PRESS START.
3.PLATEN
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. SELECT 1-16, AND PRESS
START.
(FEED TRAY)
1.TRAY1 2.TRAY2 3.TRAY3 4.TRAY4
5.BPT 6.LCC
(ABOVE+10: DUPLEX MODE)
Select other than0-2,and
press [START] key.
Press [SYSTEM SETTINGS] key.
Select 1, and
press [START]
key.1
Press [START] key.
Press [SYSTEM SETTINGS] key,
or terminate copying.
Select 0, and press [START] key.
Press [START] key,
or press [SYSTEM SETTINGS] key.
To Next Page
Loading...
