Sharp MX-M7570 - Page 810

8-14
SYSTEM SETTINGS►SETTING MODE LIST
Image Send Settings
Common Settings
U: General user; A: System administrator/Administrator
Setup Items Factory default setting U A Page
● Common Settings
 Condition Settings
 Hold settings for a while after scanning has been
completed
Disabled
No Yes
4-10
 Job Auto Start Time During Scanning 60sec. No Yes
 Default Display Setting E-mail (Fax when the
facsimile expansion kit
is installed)
No Yes
 Address Book Default Selection No Yes
4-13
• Higher priority is given to the display of address
book.
Disabled
No Yes
• Apply Addresses of Sending Modes Only Enabled No Yes
 Category Displayed as Default None No Yes
1-146
 Display all address type regardless of the mode being
displayed currently.
Disabled
No Yes
 Enlarge Address Book Enabled No Yes
 Image Orientation Portrait No Yes 4-43
 Preview Setting
• Received Data Image Check Setting Disabled No Yes 4-56
• Default List/Thumbnail Display No Yes
1-21
- Fax/I-Fax Reception Data*
1,
*
2
Thumbnail No Yes
 Default Exposure Settings Auto No Yes 4-49
 Default Original Image Type Text No Yes 5-57
 Sending the same image sent in Fax mode*
1
Disabled No Yes 4-35
 Be sure to press Next Address Key ([+]) before
selecting the next address.
Disabled
No Yes 4-35
 Scan Complete Sound Setting Middle No Yes 4-27
 Disable Switching of Display Order Disabled No Yes 1-146
 Hold Setting for Received Data Print Disabled No Yes 4-56
 Default Verification Stamp*
3
No Yes
4-8
5-11
• E-mail/Scan/Data Entry Disabled No Yes
• Fax/Internet Fax*
1,
*
2
Disabled No Yes
 Erase Width Adjustment No Yes
4-84• Edge Clearance Width 1/2" (10mm) No Yes
• Center Clearance Width 1/2" (10mm) No Yes
 Time Specified Output of Received Data Disabled No Yes 4-57