104(107)
damaged, the material may pop out from the feed box.
2) Check whether the emergency stop button works normally, then turn on the
switch for emergency stop after starting the machine. Rotate the button
according to the direction of arrow (counter-clockwise) to reset.
6.4.2 Weekly Check
1) Check the power supply wire to see whether they are worn or damaged. If so,
replace them immediately.
2) Check the performance of safety switch.
3) Check the safety switches of feed box and storage box.
Loosen the star screws on feed box and screen bracket and try to start the
machine (the machine can not be started if the door and screen bracket are not
closed completely or the star knob is not tightened completely).
Note！
Note: When inspection, the storage box should be mounted and the
door should be closed and locked tight.
6.4.3 Monthly Check
1) Check whether the belt is in good condition.
2) Check the tension of V-belt every 6 months; see chapter 6.2 "Conveying" for
details.
6.5 Cleaning
Caution！
Make sure the main power switch is turned off before cleaning.
When opening the feed box, be careful with the blades; they are very
shart and may cause personal injury.
1) Check whether the feed box and cutting chamber are empty before stopping
the machine.
2) Clean the outside surface of the feed box.
3) Loosen the star screws on feed box.
4) Open the feed box backward.
5) Clean the feed port.
6) Take out the material fender assembly and clean its both sides.
To Next Page
Loading...
Need help?
General
