94(107)
4. Operation Guide
Wear earplugs when operating to avoid personal injury!
Wear gloves when operating to avoid personal injury！
Wear goggles when operating to avoid personal injury!
Since the blades and blade shaft may be loosen, check the following
items before operating:
1) If the blades have any damage;
2) If the surface of blade shaft is loosen;
3) Push or pull the rotary blade rest and blades to see if there is any
loose.
If any of the above situations occurs, please contact the local
representative or SHINI Company.
4.1 Startup Pretest
1. Unpainted part of the machine has been spread with anti-rust oil. Before use,
clear the anti-rust oil carefully.
1) Clean it with a rag first.
2) Then wet the rag with thinner to clean it.
2. Check the clearance of blades (0.20~0.30mm) and see if the screws of
blades are locked tightly.
4.1.1 After 2 Hours of First Startup
Check the clearance of blades again, including fixed blades and rotary blades;
then check the screws of blade to see if there is any loose.
4.2 Circuit Connection
1) Connect the granulator to the power；
2) Turn on the gate circuit breaker；
3) Check if the emergency switch is on;
4) Check if the star screws on feed box and screen bracket are locked tightly
To Next Page
Loading...
Need help?
General
