16(107)
1.4 Safety Regulations
Follow the instructions in this manual to avoid personal injury and damage to
machine components.
1.4.1 Safety signs and labels
Electrical installation must only be done by a competent electrician!
Before the granulator is opened for servicing and maintenance, turn off
both the main switch and the control switch on the granulator.
Never put any part of your body through the granulator openings, unless
both the main switch and the control switch on the granulator are in "Off"
position.
High voltage! Danger!
This sign is attached on the control box and the wiring box.
Be careful with the rotating knives, they are very sharp and can cause
personal injury!
If the rotor must be turned manually-do this with great care!
The granulator should not be started before the feed box and storage box
are properly closed.
Ear protection should be used during granulating of plastic materials.
Make sure the power has been cut off before opening the feed box.
Feeding blower which requires that the temperature of regrind and dust
should not be higher than 80℃ is applicable to convey regrind and dust.
To Next Page
Loading...
Need help?
General
