SICK Advanced Series

To Next Page

To Previous Page

Operating Instructions Chapter 1

CLV490 Bar Code Scanner

Notes on this document

1 Notes on this document

1.1 Purpose

This document is a guide to the operation of the bar code scanner

• CLV490 with auto-focus

in the following variations:

• Line scanner

– CLV490-2010, resolution from 0.20 mm (7.9 mil) (high density)

– CLV490-2011, resolution from 0.20 mm (7.9 mil) (high density), with heater

– CLV490-0010, resolution from 0.30 mm (11.8 mil) (standard density)

– CLV490-0011, resolution from 0.30 mm (11.8 mil) (standard density), with heater

– CLV490-6010, resolution from 0.40 mm (15.7 mil) (low density)

– CLV490-6011, resolution from 0.40 mm (15.7 mil) (low density), with heater

• Line scanner with oscillating mirror

– CLV490-3010, resolution from 0.20 mm (7.9 mil) (high density)

– CLV490-3011, resolution from 0.20 mm (7.9 mil) (high density), with heater

– CLV490-1010, resolution from 0.30 mm (11.8 mil) (standard density)

– CLV490-1011, resolution from 0.30 mm (11.8 mil) (standard density), with heater

– CLV490-7010, resolution from 0.40 mm (15.7 mil) (low density)

– CLV490-7011, resolution from 0.40 mm (15.7 mil) (low density), with heater

This document provides information on

• Mounting and connecting the device

• Startup

• Operating and configuring (parametrizing) the device

• Maintenance

• Exchanging the device without losing the parameter set

• Special applications and procedures

The bar code scanner with all its variants will in this manual be referred to as the "CLV490",

except where a distinction is necessary.

1.2 Target audience

This document is intended for persons who are responsible for the following activities:

1.2.1 Mounting, electrical installation, maintenance and replacement

Electricians and service technicians.

1.2.2 Startup, operation and configuration

Technicians and engineers.

Related product manuals