Need help?Do you have a question about the SICK M4000 Advanced and is the answer not in the manual?
General| Type | Multiple light beam safety device |
|---|---|
| Enclosure rating | IP65 |
| Supply voltage | 24 V DC |
| Safety integrity level | SIL3 |
| Performance level | PL e |
| Protection Rating | IP65 |
| Operating Voltage | 24 V DC |
| Number of beams | 2 to 4 beams |
| Resolution | 70 mm |
| Ambient operating temperature | -25 °C ... +55 °C |
| Angular Resolution | Not applicable |
| Operating Temperature | -25 °C ... +55 °C |
Specifies requirements for personnel qualified to install, commission, and service the M4000 safety device.
Defines the conditions and personnel required for the correct and safe usage of the M4000 system.
Provides essential safety guidelines, regulations, and measures for using the M4000 safety device.
Describes the LEDs and 7-segment display used for signaling the M4000's operating status.
Explains the core concept of muting for temporarily disabling safety functions during material transport.
Lists and categorizes external sensors used for detecting material during muting operations.
Provides guidelines for correctly positioning muting sensors to ensure proper detection and safety.
Describes the restart interlock function for preventing machine restart after interruption.
Explains how to configure the scanning range to match the light path dimension.
Defines the sensor combinations (2-4 sensors) for realizing muting functions.
Covers time-based monitoring functions like concurrence and total muting time.
Covers manual triggering of muting after an error to clear the system.
Explains the critical need to maintain minimum safety distances for the M4000 device.
Provides formulas and examples for calculating minimum safety distance per EN standards.
Details methods for calculating minimum safety distance according to ANSI and OSHA regulations.
Specifies the minimum distance required from reflective surfaces to prevent detection errors.
Explains how to calculate the minimum distance to reflective surfaces using diagrams and formulas.
Outlines the procedural steps for correctly mounting the M4000 sender and receiver units.
Details the pin assignment and connection for the M4000 system connection.
Details the electrical implementation and connection for external device monitoring.
Explains the correct installation site and function of the reset button.
Explains the process of aligning the sender and receiver components of the M4000.
Provides step-by-step instructions for physically aligning the sender and receiver.
Details the use of the integrated laser alignment aid for precise device adjustment.
Provides a procedural guide for aligning the M4000 using its laser alignment system.
Outlines essential tests required for ensuring the protective device's effectiveness.
Describes daily checks to verify the proper functioning of the M4000 safety device.
Outlines the necessary steps and tools for preparing the M4000 device configuration.
General procedure for handling malfunctions and performing function tests after fault rectification.
Interprets error messages indicated by the LEDs on the M4000 device.
Details the error messages shown on the 7-segment display and their remedies.
Step-by-step instructions and illustrations for aligning M4000 devices.
To Next Page
