Name: SICK Advanced Series
Brand: SICK
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Operating Instructions Chapter 10

CLV490 Bar Code Scanner

Appendix

10.3.8 Replacing a CLV490

The device is replaced by starting the new CLV490 with the S

TART WITH EXTERNAL PARAMETERS

option (default). This is the case when the device is put into service for the first time, e. g.

when it is taken from the warehouse. The device must be replaced with a device of the same

type. You do not need to connect a PC to replace the device.

¾ Replace the device as described in Chapter 10.12.2 Importing the parameter set from

the external memory, Page 10-74.

The CLV490 imports the external parameter set into the RAM. This is sufficient to ensure

that the device operates correctly. If the parameter set is to be stored permanently in the

CLV490 (EEPROM), a PC with the "CLV-Setup" program must be connected to upload the

parameter set from the CLV490 to CLV-Setup and then download it again to the CLV490

with the P

ERMANENT storage option. When asked to do so, adjust the external memory again.

WWW.100Y.COM.TW WWW.100Y.COM.TW WWW.100Y.COM.TW

Light Source

LED, visible red light (660 nm)

Protection Class

IP65

Typical Scan Rate

500 scans/s

Ambient Operating Temperature

0 °C ... +50 °C

Power Supply

10 V DC ... 30 V DC

SICK Advanced Series User Manual

Questions and Answers: