SICK DME5000 User Manual

Chapter 13 Operating Instructions
DME5000
134 © SICK AG • Germany • Subject to change without notice 8009813/ZJV1/2017-05
Annex
Parameterization of MF1 and MF2
Device versions DME5000-xx5 are only equipped with a 5-pin DeviceNet plug. The
multifunction in- and outputs MF1 and MF2 are not available in the hardware.
Parameters for MF1 and MF2 can be set anyway and the result can be requested in the
diagnosis byte (see section 13.7.3 "Data Exchange") via the bus.
Parameterization as input is not possible. The functions speed mode and preset can be
used via the "Class Instance Editor".

ATTENTION

SICK DME5000 Specifications

General

Brand	SICK
Model	DME5000
Category	Measuring Instruments
Language	English