Chapter 7 Operating Instructions
DME5000
90 © SICK AG • Germany • Subject to change without notice 8009813/ZJV1/2017-05
Interface
Depending on device type, the menu only displays the respective device type interface.
SSI
For SSI interface function, see chapter 12 "Terms – SSI".
Coding
Binary Gray (Default)
Measured value output in binary code Measured value output in gray code
Mode
Data format
Binary Gray
25 bit (default) Measured value: Bit 1 ... 24
LSB: Plausibility bit
Measured value, incl.
plausibility bit encoded in
gray code
24 bit + err Measured value: Bit 1 ... 24
LSB: Plausibility bit
Measured value: Bit 1 ... 24
LSB: Plausibility bit
24 bit Measured value: Bit 0 ... 23 Measured value: Bit 0 ... 23
Plausibility bit: 0: OK
1: Plausibility error
0: OK
1: Plausibility error
Activation
On (default) SSI interface in operation, RS-422-interface not in
operation.
Off RS-422-interface in operation, SSI-interface not in
operation. The RS-422-interface enables
parameterization of the DME with the interface adapter
(see section 13.4 "Interface Adapter").
(Set baud rate and protocol in > 3.2 Serial <)
Monitor
On Serial monitor interfaces in operation, multifunctional
outputs MF1 and MF2 not in operation. Enables
parameterization of the DME5000 with the interface
adapter (see section 13.4 "Interface Adapter") or listening
in on measured values via MF1 and MF2 during SSI
operation. The active monitor interface is displayed in the
menus 3.3.2 and 3.4.2 MF-Function as "Monitor". The SSI
interface is fully functional (set baud rate and protocol in
> 3.2 Serial <).
Off (default) Multifunctional outputs MF1 and MF2 in operation as set
in item 3.3/3.4.
PROFIBUS
®
To Next Page
Loading...
