SICK GM32 - Further Components on the Measuring Point; Connection Unit and Cabling

86 GM32 · Technical information · 8011923 · V 1.4 · © SICK AG
Shutting down/Restarting
Subject to change without notice
6.3 Further components on the measuring point
6.3.1 Connection unit and cabling
If the existing cabling at the measuring point is no longer required in its present form,
remove the cabling as described in the following.
 Disconnect all lines provided by the customer from the terminal strip of the connection
unit.
 Loosen the fastening of the connection unit.
 Remove the connection unit with all pre-assembled cables with plugs.
● If there are problems in removing the pre-assembled cables with plugs together with the
connection unit:
 Disconnect the pre-assembled cables from the terminal strip in the connection unit
and remove these from the installation ducts or installation location.
If the cables provided by the customer at the measuring point can be used for other
purposes:
 Insulate all open cable ends.
 Protect the cable ends against atmospheric conditions, e.g., with a close box to prevent
corrosion and contamination.