Shutting down/Restarting
GM32 · Technical information · 8011923 · V1.4 · © SICK AG 89
Subject to change without notice
6.5 Preparing for restarting
6.5.1 New measuring task
If the planned measuring task is different to the original task (e.g., modified sample gas
composition, different measuring point):
Ask SICK Service or the responsible sales partner whether a new factory calibration is
required for the changed measuring task and which system components may have to
be returned (usually the SR-unit).
If a factory calibration is necessary:
If the measuring system has not been stored in the meantime, prepare it for transport
as described in §6.4 (
p. 87).
The original packaging is best suited for shipping. The packaging must always provide
sufficient protection for transport.
Send the SR-unit and/or other system components as agreed to the address specified
by your SICK contact person.
6.5.2 Previous measuring task
If a factory calibration is not necessary for the new measuring task and the measuring
system is used for the new measuring task without intermediate storage:
Clean the outside of the closed SR-unit housing and the connected measuring probe
with damp cleaning cloths. Pay special attention to removing chemical residues or
condensate deposits. A mild cleaning agent that does not leave any residues can be
used here.
6.5.3 Purge air unit maintenance
On measuring systems with purge air unit:
Perform maintenance on the purge air unit before restarting.
To Next Page
Loading...
Need help?
General
