SICK miniTwin4

!
"
§
Figure 44: L-Fix bracket, part no. 2045843
!
Washers
"
1. M5 fixing screw
§
2. M5 fixing screw (optional)
Important information
NOTE
Mount
ing with 2 L-Fix brackets is only permitted up to a protective field height of
540 mm.
NOTE
b
T
ighten the screws of the L-Fix bracket with a torque of about 3 Nm. Higher
torques can damage the bracket; lower torques provide inadequate protection
against vibrations.
Approach
1.
Mount t
he L-Fix bracket (!) with assembled mounting limb (") on the mounting
surface so that the twin stick is positioned at the correct height.
2.
Mount the mounting plate (§) of the upper L-Fix bracket so that the upper twin
stick protrudes up to 1 mm.
3. At a protective field height of 420 mm, use 2 fixing screws per mounting plate to
increase protection against the L-Fix bracket twisting.
4.
Set the mounting limb ($) of the L-Fix bracket on the upper end cap of the twin
stick.
5.
Fasten the screws of the L-Fix bracket (%) with a torque of about 1.5 Nm to
achieve a corresponding clamping force of the bracket.
5 MOUN
TING
54
O P E R A T I N G I N S T R U C T I O N S | miniTwin4 8012624/10OM/2018-08-09 | SICK
Subject to change without notice