Figure 47: Mounting the miniTwin4 with C-Fix bracket and L-Fix bracket
5.
Mount t
he C-Fix bracket (§) at the other end of the twin stick.
For devices with a protective field height of ≥ 360 mm, w
e recommend also using
an additional C-Fix bracket in the direct vicinity of the L-Fix bracket if there are
strong cross forces on the housing.
6.
Inser
t the twin stick into the C-Fix bracket and press it downward gently ($).
7.
Turn the twin stick to the rear until it engages in the C-Fix bracket (%).
8. Turn the twin stick downwards until it is correctly positioned in the L-Fix bracket
(&).
9.
Tighten the M3 screws of the L-Fix bracket (/) with a torque of about 1.5 Nm.
10. To secure the twin stick ( ), tighten the M3 screws of the C-Fix bracket with a
torque of approx. 1.5(Nm.
5.4.7 Mounting with C-Fix-Flex bracket
Overview
T
he C-Fix-Flex bracket can be positioned very flexibly on the twin stick. It does not
extend the dimensions of the miniTwin4 safety light curtain.
With the C-Fix-Flex bracket, twin sticks can be mounted until they make contact or at
right angles to each other without harming the resolution at the junction points.
With the C-Fix-Flex bracket, twin sticks can be mounted so that the protective field is
either parallel or perpendicular to the mounting surface. The C-Fix-Flex bracket makes it
possible to correct the mounting bracket by ± 4°.
5 MOUN
TING
56
O P E R A T I N G I N S T R U C T I O N S | miniTwin4 8012624/10OM/2018-08-09 | SICK
Subject to change without notice
To Next Page
Loading...
