EasyManua.ls Logo

SICK S3000 Cold Store

SICK S3000 Cold Store
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Minimum Typical Maximum
Test pulse width
9)
230 µs 300 µs
Test frequency
At 0.5° angular resolution 120 ms
At 0.25° angular resolution 240 ms
Power-up delay of the OSSDs from red to green 120 ms
Time offset on switching the OSSDs between
O
SSD2 and OSSD1
1.3 ms 2 ms
UNII/O1, 2 and 3
Switching voltage HIGH at 200 mA U
V
– 3.3 V U
V
Source switching current 100 mA 200 mA
Current limiting (after 5 ms at 25 °C) 600 mA 920 mA
Switch-on delay 1.4 ms 2 ms
Switch-off delay 0.7 ms 2 ms
Response time of the warning field output or UNI-
I/O1, 2 and 3 on conf
iguration as warning field out‐
put
Corresponds to the resulting response
time of the OSSDs plus supplement
Supplement for 0.25° angular resolution 50 ms
Supplement for 0.5° angular resolution 25 ms
Configuration and diagnostic interface
Communication protocol RS232 (proprietary)
Transmission rate 38,400 Baud
Cable length for 9,600 Baud and 0.25 mm²
c
ables
15 m
Galvanic separation No
Output TxD HIGH 5 V 15 V
Output TxD LOW –15 V –5 V
Voltage range RxD –15 V 15 V
Switching threshold RxD LOW –15 V 0.4 V
Switching threshold RxD HIGH 2.4 V 15 V
Short-circuit current at TxD –60 mA 60 mA
Maximum voltage level at RxD –15 V 15 V
Maximum voltage level at TxD –11 V 11 V
Safe SICK device communication via EFI/SDL
Cable length for 500 kBaud and 1 × 2 ×
0.22 mm² c
ables
50 m
Galvanic separation Yes
Cable type to be connected Twisted pairs with copper braid screen,
c
able diameter ≤ 6.8 mm
Wire cross-section of the cable to be connected 1 × 2 × 0.22 mm²
1)
To meet the requirements of the relevant product standards (e.g., IEC 61496-1), the external voltage sup‐
ply for the devices must be able to bridge a brief mains failure of 20 ms. Power supply units according to
EN 60204-1 fulfill this prerequisite. Suitable power supply units are available as accessories from SICK.
2)
The load currents for the input capacitors are not taken into account.
3)
With a typical supply voltage of 24 V.
4)
Ferrules are not needed.
5)
Applies to the voltage range between U
s
and 0 V.
TECHNICAL DATA 12
8012029/ZA20/2019-11-14 | SICK O P E R A T I N G I N S T R U C T I O N S | S3000 Cold Store
111
Subject to change without notice

Table of Contents

Other manuals for SICK S3000 Cold Store

Related product manuals