2 SAFETY INFORMATION
8023994-17I6/2020-03-19|SICK
ORIGINAL OPERATING INSTRUCTIONS| VMS4100/5100
Subject to change without notice
2.4 Sources of hazard
Laser class 2 can cause serious eye injuries if the following points are not observed:
▸
Never look directly into the laser beam.
▸
Never point the laser beam at people’s eyes.
▸
During commissioning or maintenance work, suitable eye protection must be worn.
▸
Do not open the housing.
▸
Current national regulations regarding laser protection must be observed.
Touching live devices, which may still be energized, can lead to death, burns or electrical
shock.
▸
Electrical work may only be performed on the system by qualified specialist personnel.
▸
Before working on electrical components, observe the five safety rules:
▸
Disconnect.
▸
Secure against being switched back on.
▸
Ensure that there is no voltage.
▸
Ground and short-circuit.
▸
Cover or enclose live parts in the vicinity.
▸
Never enter the area under suspended loads.
▸
Pay close attention when lifting loads.
▸
Comply with lifting instructions to prevent injuries and accidents.
▸
Use suitable, undamaged lifting tools.
▸
Wear personal protective equipment (safety helmet, safety shoes).
2.5 Protective devices
The multi-dimensional measurement system is designed in a way that allows for safe
operation. Protective devices reduce potential risks to the maximum possible extent.
• Laser protective cover for the LMS4x21 2D LiDAR sensor
2.6 Warranty
The warranty will become null and void if any of the following occur:
▸
The safety notes and measures in this document are not observed.
▸
Parts or components of the multi-dimensional measurement system have been
installed, mounted or modified without authorization.
▸
The multi-dimensional measurement system has been altered or modified.
▸
The software has been modified, customized, and/or tampered with without
authorization.
Optical radiation:
Laser class 2
Electrical voltage
Suspended loads
To Next Page
Loading...
