COMMISSIONING 6
8023994-17I6/2020-03-19|SICK
Subject to change without notice
ORIGINAL OPERATING INSTRUCTIONS| VMS4100/5100
6 Commissioning
Commissioning may only be performed by qualified persons.
• Qualified persons have the specialist training, skills, and experience, as well as
knowledge of the relevant regulations and standards, to be able to perform work
assigned to them and to identify and avoid any potential dangers independently.
• Electricians have the professional training, skills and experience, and knowledge of
the relevant standards and provisions to work on electrical systems and to detect and
avoid any potential dangers independently.
• Initial commissioning of the multi-dimensional measurement system is performed by
the manufacturer.
• All of the system functions are set up by configuring the measuring conditions on-site.
NOTE! Initial commissioning by the manufacturer is not covered in these supplementary
operating instructions.
6.1 Switching on the system
▸
Establish the supply of voltage to the devices via the power supply units in the
SIC2000.
All system components automatically start up.
• Self-diagnosis is performed to check the operational readiness of the devices.
• During the power-up cycle, the status indicators show the device status.
NOTE! The system in which the multi-dimensional measurement system is integrated
is put into operation via the higher-level control.
VMS4100/5100
Internal check for
operational readiness
To Next Page
Loading...
Need help?
General
