3 SYSTEM DESCRIPTION
8023994-17I6/2020-03-19|SICK
ORIGINAL OPERATING INSTRUCTIONS| VMS4100/5100
Subject to change without notice
3.2.4 Cabinet
Fig. 6: SIC2000 cabinet
Legend
1 Air inlet for cooling (with filter mat and cooler)
2 SIM2000 system controller (with alibi memory on the VMS5100)
3 Terminals for voltage supply IN (100–264 V AC / 50–60 Hz)
4 Air outlet for cooling (with filter mat)
5 Power supply unit for supplying voltage to the SIM2000 and 2D LiDAR
sensors
6 Terminals (24 V DC) and fuse module OUT
7 Power supply unit for voltage supply to LFT display (VMS5100 only)
• Contains power supply units for the central voltage supply to system components.
• Contains the SIM2000 system controller, the central processing and control unit of the
VMS4100/5100.
• The SIM2000 system controller contains the legally relevant memory (alibi memory).
• Central power supply for all system components.
• Coordinates all connected sensors and processes the measured values received.
• The SIM2000 system controller receives the measuring points from the 2D LiDAR
sensor and uses the 2D sections to calculate a three-dimensional model.
• Determines the box volume and dimensional values based on the calculated 3D model.
• The data is sent to the higher-level customer system via the system controller in a host
telegram with a defined format.
NOTE! In the case of the VMS5100, the measurement results are saved in the
SIM2000 alibi memory, which is required for legal-for-trade verification.
Cabinet without
Ethernet switch
Properties
Function
To Next Page
Loading...
