3 SYSTEM DESCRIPTION
8023994-17I6/2020-03-19|SICK
ORIGINAL OPERATING INSTRUCTIONS| VMS4100/5100
Subject to change without notice
NOTE! Depending on the cabinet variant, the LFT display can be connected directly to the
system controller or to the LFT switch.
Fig. 31: Configuring the time of the data output
Legend
1 Free-running operating mode: issue as soon as possible after leaving the
scanning line.
2 Triggered operating mode: after a defined distance from X position in
relation to the rear edge of an object.
3 Triggered operating mode: after a defined distance from X position in
relation to the leading edge of an object.
• The output time is configured using SOPAS.
• Issue depends on the triggering mode selected.
Configuring
output times
To Next Page
Loading...
