SICK VMS4200

MAINTENANCE AND REPAIR 7
105
8022965-17I6/2020-03-19|SICK
Subject to change without notice
ORIGINAL OPERATING INSTRUCTIONS| VMS4200/5200 (Multicontroller)
7.2.3 Replacing the incremental encoder components
If the incremental encoder is defective, it must be replaced immediately.
Part No. Meaning
2058477 DFV60 incremental encoder
WARNING
Do not violate LFT mode on the VMS5200 (Mult icontroller)
The VMS5200 multi-dimensional measurement system (Multicontroller) is operated in
LFT mode.
▸
Do not replace the incremental encoder yourself.
▸
Do not break any adhesive seals.
▸
If repairs are required, contact the manufacturer.
▸
Unscrew the M12 plug connector from the male connector on the incremental encoder.
▸
Loosen and remove the fixing screws.
Fig. 84: Replacing the incremental encoder
▸
Mount the replacement device on the conveyor belt (for more information, see chapter
4.2 Mounting the incremental encoder).
NOTE! Observe the correct mounting direction.
▸
Screw the M12 plug connector onto the male connector on the incremental encoder.
Replacement device
Removing
a defective encoder
Mounting the
replacement device