SICK VMS4200

ELECTRICAL INSTALLATION 5
69
8022965-17I6/2020-03-19|SICK
Subject to change without notice
ORIGINAL OPERATING INSTRUCTIONS| VMS4200/5200 (Multicontroller)
5 Electrical installation
All electrical work may only be performed by qualified persons.
• Qualified persons have the specialist training, skills, and experience, as well as
knowledge of the relevant regulations and standards, to be able to perform work
assigned to them and to identify and avoid any potential dangers independently.
• Electricians have the professional training, skills and experience, and knowledge of
the relevant standards and provisions to work on electrical systems and to detect
and avoid any potential dangers independently.
DANGER!
HAZARDOUS ELECTRICAL VOLTAGE
The system is supplied with line voltage. Risk of electrical shock. Contact will result
in death, burns or shock.
▸
Electrical work may only be performed on the system by qualified specialist
personnel.
▸
Interrupt the voltage supply.
▸
Check residual voltage on the system components.
▸
Use additional caution.
▸
Always connect equipotential bonding (earthing).
▸
Do not disconnect or remove the protective conductor.
▸
The voltage supply must be disconnected when attaching or detaching electrical
connections.
DANGER!
HAZARDOUS ELECTRICAL VOLTAGE
An incorrect supply voltage may result in damage to the device.
▸
Only operate the cabinet with the specified supply voltage.
▸
All connected circuits must be designed as SELV circuits (in accordance with
EN 60950 or ES1 EN 60368-1).
NOTE!
The connections of the VMS5200 (Multicontroller) system, which can be verified as legal
for trade, may differ from the connections of the VMS4200 (Multicontroller) depending
on the project.