4 MOUNTING
8022965-17I6/2020-03-19|SICK
ORIGINAL OPERATING INSTRUCTIONS| VMS4200/5200 (Multicontroller)
Subject to change without notice
4.1.3 Mounting telescopic tube to the frame
Fig. 57: Attaching the telescopic tube to the frame
▸
Attach the telescopic tube to a profile using the mounting and spring plate that is pre-
mounted on the base tube.
4.1.4 Fastening the 2D LiDAR sensors to the mounting plates
Fig. 58: Fastening the 2D LiDAR sensors to the mounting plates
Each mounting plate has an injection bush on its rear side to accommodate the 2D LiDAR
sensor. This coding prevents the device from being incorrectly rotated by 180° when
mounted.
▸
Insert the injection bush of the mounting plate into the locating hole of the 2D LiDAR
sensor.
▸
Press the device into place with one hand and screw the device to the mounting plate.
▸
Make sure that the device is securely screwed on.
Mounting
Mounting
To Next Page
Loading...