7 MAINTENANCE AND REPAIR
8022965-17I6/2020-03-19|SICK
ORIGINAL OPERATING INSTRUCTIONS| VMS4200/5200 (Multicontroller)
Subject to change without notice
7.2.2 Replacing the deflector mirror
NOTE! Do not remove protective foil of the deflector mirror until mounting is complete.
WARNING
Loss of MID conformity after replacing a component
The deflector mirror is part of the legal for trade system.
Due to the replacement of a component, the VMS5200 (Multicontroller) will no longer
be verified as legal for trade.
▸
After replacing a component, contact the manufacturer.
▸
The manufacturer will arrange for the system to be reverified after the replacement
of a component.
Fig. 83: Deflector mirror removal
▸
Mark the installed position of the deflector mirror in the mounted state (e.g., using the
hole pattern).
▸
Undo and remove the two fixing screws on the two 180° mounting brackets.
NOTE! For this, the deflector mirror needs to be held and secured against falling by
a second person.
Remove the deflector mirror from the bracket.
▸
Insert the new deflector mirror into the 180° mounting bracket.
▸
Fasten the deflector mirror onto the bracket with the two fixing screws.
▸
Remove the protective film from the new deflector mirror.
Check that the deflector mirror is aligned correctly.
Removing a defective
deflector mirror
Mounting a new
deflector mirror
To Next Page
Loading...