SICK VMS4200

SYSTEM DESCRIPTION 3
33
8022965-17I6/2020-03-19|SICK
Subject to change without notice
ORIGINAL OPERATING INSTRUCTIONS| VMS4200/5200 (Multicontroller)
Fig. 21: Dynamic scale value switchover (length dimension as switchover point)
Legend
1 Switchover point 2,000 mm
2 Identification label for scale interval value 1
3 Identification label for scale interval value 2
In example 1, the multi-dimensional measurement system is working with the two scale
interval values 5 mm x 5 mm x 5 mm and 10 mm x 5 mm x 5 mm. An object length of
2,000 mm has been defined as the switchover point during commissioning.
Objects with a length less than or equal to 2,000 mm are measured with scale interval
value 1 (5 mm x 5 mm x 5 mm). For objects with a length greater than 2,000 mm, the
multi-dimensional measurement system automatically uses scale interval value 2 (here
10 mm) for the length dimension due to the detected object length, and continues to use
scale interval value 1 (here 5 mm x 5 mm) for the width and height.
Example 1