System Overview 15
Display and power panel
1) READY lamp lights when the instrument is
ready.
2) START lamp lights when analysis is being
performed.
3) ALARM lamp lights when a problem occurs.
4) SYSTEM RESET button resets the computer
controlling the instrument (not normally used).
5) EMERGENCY STOP button is pressed to
stop the instrument in an emergency.
WARNING
If you stopped the system using the
Emergency Stop button, you must
perform a Weekly wash (WASH2)
prior to processing samples.
6) OPERATE/STANDBY switch turns the
analyzer power ON (OPERATE) or OFF
(STANDBY).
7) POWER lamp lights when the analyzer power
is ON.
Figure 1-3. Power panel
Analyzer back view
1) Main Power Switch
(powers the entire
instrument)
2) Water Supply and
Drainage Panel
3) Circuit breaker panel
Figure 1-4. Analyzer back view
To Next Page
Loading...
