36 ADVIA 2400 Operator’s Guide
Software Overview
This section of the manual describes the software windows available to configure and run
your chemistry system. It does not explain how to use these windows. For detailed
information on the use of the windows, refer to the online Operator’s Guide.
The software controls most of the functions run by the chemistry system. The software,
which runs under the Windows operating system, starts automatically when you turn on
the PC.
You start the software from the Startup window, and stop it from the Menu Panel.
After the software has started, the Menu Panel and the Operation Panel appear at the top
of your screen.
As long as the software is running, these windows remain in the same position (unlike
most Windows XP windows). Use the top display option (Systems(s)) to allow other
windows to display on top of the Menu Panel and Operation Panel.
Startup window
The Startup window is the first window you see when you turn on the PC and the last
window when you stop the system.
Perform any of the following tasks at this window:
• new start
• restart
• back up and restore system files
• set or clear the system data prior to startup.
• shut down and restart Windows
1. At the Menu Panel, select
System (s), then select Exit (X).
2. Select
Yes when prompted, then select Yes when prompted again.
The
Startup window appears.
If you select
Cancel, the Startup window closes, leaving you in Windows (you are not
able to perform the above functions). To open the Startup window again, restart
Windows.
Operation Panel
This window opens after you start the system software from the Startup window.
Use this window for the following tasks:
• perform routine tasks on the Chemistry system
• check the system status and alarm messages
To Next Page
Loading...
