Siemens ADVIA 2400 - Batch Transmission to a Host Computer; Printing Sample Data

Quality Control 87
Batch transmission to a host computer
Use the Review/Edit window to transmit selected patient results. The data clean feature is
available to check the sample results for problems.
Printing sample data
The Print report window is only available from the supervisor logon. To print reports, go
to the Review/Edit window and use the Print report button.
CAUTION
Tests on the Print Report form must be in the same order as they appear at the System
Test List window, to avoid incorrect positioning of results on the print report. Do not
modify the order of the test names at the System Test list window after the initial
setup. Any repositioning of test names on the System Test list window could result in
associating already-run tests with the wrong test name.
1. At the Menu Panel, select
Request, then select Review/Edit.
2. At the Review/Edit window, select the
Print Report button.
3. At the Print Report window, select a Sample Type(T) and File Data(F).
a. If you select Archive in the File Data (F) field, the Filing File Name (I) field is
activated.
b. Select the
Open button.
c. Select a file name at the Open window.
4. In the Specification range (R) field, select the
arrow in the field and select Input
Range
or All from the list.
5. In the Number entry format (N) field, select the
arrow in the field and select a format
from the list.
6. In the Last no. entry format (E) field, select the
arrow in the field and select a format
from the list.
7. In the Report Form File (O) field, select a print format for the report.
a. Select the
Open button.
b. The Open window displays, defaulting to the ETC folder.
c. Two sample report formats are available:
• the Chart.frm file is formatted for a single sample.
• the Consoled.frm file is formatted for multiple samples.
d. Customer defined print formats also display in the folder.
e. At the Open window, select a file name for the report format.
f. Select Open.
8. Enter a start number in the Start number (S) field and a last number in the Last
number (L) field.