System Overview 43
Review/Edit window
CAUTION
Tests on the Review/Edit window must be in the same order as they appear in the
System Test List window to avoid incorrect positioning of results on the print report.
You must not modify the order of the test items on the System Test List window after
initial setup. If you reposition any test items on the System Test List window, results
for samples already run could be associate with the wrong test name.
Perform any of the following tasks at this window:
• review sample results
• configure reruns
• print selected patient results
• transmit selected patient results
Reaction Monitor window
Use this window to observe changes in reaction data. The changes are depicted as a
function of time, or of the 98 detection points in an analysis.
In the window, you choose a test and a sample for which you want to display a reaction
over time. Once you make your choice, a graph is created. You can choose several plots
for the graph.
Perform any of the following tasks at this window:
• Check test reaction data over time
• Show the reaction data
• Check the time courses for all wavelengths
• Check cell blank values
• Change the scale of absorbance graph
• Create a file containing test data
• Print the data list
RealTime Monitor window
The system monitors calibration, control, and patient sample results in real time. Only
patient and control sample results can be transmitted to a host computer. Results are
reported after the sample analysis is complete.
To Next Page
Loading...
