60 ADVIA 2400 Operator’s Guide
NOTE: Please contact your local technical support provider or distributor before
changing the default settings on this window.
System Parameters Settings window*
Use this window to enter or change system parameters, which define the system
processing environment.
Perform any of the following tasks at this window:
• define and edit system parameters
• view system parameters
• print system parameters
Reflex Test Settings window*
Use this window to define reflex testing for reagent methods. You can define up to three
reflex tests for any given test method based on a set of user defined conditions. When all
conditions are true, the specified reflex tests are added to a sample workorder. The
system tracks the workorder as a pending rerun until the reflex tests are completed.
Reflex tests display in the Prev. val. column in the Review/Edit window.
To define reflex testing for a given method, you must list the reagent in the System Test
List window.
Other Tasks
Use the System(S) menu in the top left corner to perform the following tasks:
• change the Top display option
• log on at a different access level
Use this procedure to log on as a tech_manager or a supervisor (when you start the
system, you are automatically logged on as a user). If you are already logged on as a
tech_manger or supervisor, you can log back on as a user.
• change the system password
Use this procedure to change the password for the supervisor ID.
• display version information and read or write a memo (see Version Information
window below)
Use this procedure to get information about the files currently in the software.
• print the screen
• log on a different user
Use this procedure to log on a different user. All results obtained for this operator will be
annotated with the corresponding user code from the User Code Settings window.
• exit the system
Use this procedure to close the software.
To Next Page
Loading...
