Siemens ADVIA 2400 - Menu Panel; Other Tasks Accessed from System(S) on the Menu Panel

38 ADVIA 2400 Operator’s Guide
Menu Panel
The Menu Panel opens after you start the system software (from the Startup window).
The window contains the buttons shown below. Use these buttons to access other menus.
Request Calibration Maint.
Reagent QC Setup
Figure 1-30 Menu Panel
Other tasks accessed from System(s) on the Menu Panel
1. To access the drop-down menu, select System(S) at the top left of the window.
2. Perform any of the following tasks:
• log on at a different access level
• change the system password
• display version information, and read or write a memo
• print the screen
• log on as a different user
• exit the system
Logging on at a different access level
Use this procedure to log on as a supervisor or tech_manager (when you start the system,
you are automatically logged in as a user). If you are already logged in as supervisor or
tech_manager, you can log back in as a user.
1. At the System(S) menu, select
Password.
2. Enter the new user name (access level) and the corresponding password.
Or, do not type a password at the Password window to log in as a user.
3. Select
OK.
You are now logged in as the new user.